MAINTENANCE
CAUTION :
Always be sure that the tool is switched off inspection and maintenance.
Replacingcarbon brushes
Remove and check the carbon brushes regularly, Replace when they wear down to about 6 mm (1/4") or less. Keep the brushesclean and free to slip in the holders. Both brushes should be changed a t the same time. Use only Makita carbon brushes.
Loosen the screw and slide the cover plate aside.
Use a screwdriver to remove the brush holder cap as shown in the figure.
and unplugged before attemptingto perform
U
6mm (1/4")
LCover plate
Brush holder cap / | / Screwdriver |
6
