Makita 5402NA ACCESS ORIES

Remove and check the carbon brushes regularly. Replace

when they wear down to the limit mark. Keep the carbon

brushes clean and free to slip in the holders. Both carbon

brushes should be replaced at the same time. Use only iden-

tical carbon brushes.

Use a screwdriver to remove the brush holder caps. Take out

the worn carbon brushes, insert the new ones and secure

the brush holder caps.

After replacing brushes, plug in the tool and break in brushes

by running tool with no load for about 10 minutes. Then

check the tool while running and electric brake operation

when releasing the switch trigger. If electric brake is not

working well, ask your local Makita service center for repair.

To maintain product SAFETY and RELIABILITY, repairs, any

other maintenance or adjustment should be performed by

Makita Authorized or Factory Service Centers, always using

Makita replacement parts.

ACCESS ORIES CAUTION:

•These accessories or attachments are recommended for

use with your Makita tool specified in this manual. The

use of any other accessories or attachments might

present a risk of injury to persons. Only use accessory

or attachment for its stated purpose.

If you need any assistance for more details regarding these

accessories, ask your local Makita service center.

•Steel & Carbide-tipped saw blades

•Rip fence (Guide rule)

•Hex wrench 6

1. Limit mark

001145

1. Brush holder cap

2. Screwdriver

001979

Combination General purpose blade for fast and smooth rip,

crosscuts and miters.

Crosscutting For smoother cross grain cuts. Slices cleanly

against grain.

Rip-cutting Fast cuts with the grain. Large teeth for better

chip clearance and minimal binding.