Makita 6812 ASSEMBL Y

ASSEMBLY CAUTION:

•Always be sure that the tool is switched off and

unplugged before carrying out any work on the tool.

To remove the bit, first pull the locator out of the locking

sleeve.

Hook the neck of the bit with one of the holes on the locator

and pull. The bit is thus easily removed.

To install the bit, insert it as far as it will go through the open-

ing in the soft rubber collar (dust ring) on top. Then press

straight down on the bit tip until it is held in place.

After installing the bit, install the locator by pushing it firmly

back onto the locking sleeve.

Use the rubber cap when fastening easily-marked work-

pieces.

1. Locator

2. Locking sleeve

002651

1. Locator hole

2. Bit neck

002658

1. Rubber collar (Dust ring)

002659

1. Rubber cap

2. Locator

002670