6
1. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit into the sleeve as far as
it will go. Then release the sleeve to secure the bit.
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
•If the bit is not inserted deep enough into the
sleeve, the sleeve will not return to its original posi-
tion and the bit will not be secured. In this case, try
re-inserting the bit according to the instructions
above.
Hook
The hook is convenient for temporarily hanging the tool.
This can be removed without using a tool. This can be
installed on either side of the tool.
Installing and removing hook
A) Removal
Remove the battery cartridge from the tool.
Place the tool in a stable and level surface.
Expand an far end of the hook outward and slide it down
while expanding.
Expand the other far end in the same manner.
Keeping the hook in this position, rotate down to the
angle 90°and remove it by pulling in the direction of arrow
as shown in the figure.
B) Installation
Remove the battery cartridge from the tool.
Place the tool in a stable and level surface.
Hold both hooking ends in the upper position and expand
the upper part of the hook.
1. Bit
2. Sleeve
1 2
001267
007029
007030
007031
007032
90
007033
007034