0 When YOU charge a new battery cartridge or a battery cartridge which has not been used for a long period, it may not accept a full charge. This i s a normal condition and does not indicate a problem. You can recharge the battery cartridge fully after discharging it almost completely a couple of times.
If you wish to charge two battery cartridges, allow 15 minutes between chargings on the fast charger.
Selecting action mode
Rotation with hammering:
For drilling in brick, concrete block, etc., move the change lever to the uou$> posi- tion. Be sure to use a concrete and masonry drilling bit.
Rotation only :
For drilling in wood, metal or plastic mate- rials, move the change lever to the GEE position. Use a conventional bit for drilling in wood or metal.
Installing or removing drill bit or driver bit
CAUTION :
Always be sure that the tool is switched off and the battery cartridge is removed before installing or removingthe bit.
Hold the ring and turn the sleeve counter- clockwise to open the chuck jaws. Place the bit in the chuck as far as it will go. Hold the ring firmly and turn the sleeve clock- wise to tighten the chuck.
To removethe bit, holdthe ring andturn the sleeve
When not usingthe driver bit, keep it in the storage cavity on the tool.
