Makita 9015A AC C E S S O R I E S

Remove and check the carbon brushes regularly. Replace

when they wear down to the limit mark. Keep the carbon

brushes clean and free to slip in the holders. Both carbon

brushes should be replaced at the same time. Use only iden-

tical carbon brushes.

Use a screwdriver to remove the brush holder caps. Take out

the worn carbon brushes, insert the new ones and secure

the brush holder caps.

To maintain product SAFETY and RELIABILITY, repairs, any

other maintenance or adjustment should be performed by

Makita Authorized or Factory Service Centers, always using

Makita replacement parts.

ACCESSORIES CAUTION:

•These accessories or attachments are recommended for

use with your Makita tool specified in this manual. The

use of any other accessories or attachments might

present a risk of injury to persons. Only use accessory

or attachment for its stated purpose.

•Your tool is supplied with a guard for use with a

depressed center grinding wheel, multi-disc and wire

wheel brush. A cut-off wheel can also be used with an

optional guard. If you decide to use your Makita grinder

with approved accessories which you purchase from

your Makita distributor or factory service center, be sure

to obtain and use all necessary fasteners and guards as

recommended in this manual. Your failure to do so could

result in personal injury to you and others.

If you need any assistance for more details regarding these

accessories, ask your local Makita service center.

1. Limit mark

001145

1. Brush holder cap

2. Screwdriver

001152