Specific Safety Rules
1.Always use proper guard with grinding wheel. A guard protects operator from broken wheel fragments.
2.Accessories must be rated for at last the speed recommended on the tool warning label. Wheels and other accessories running over rated speed can fly apart and cause injury.
3.Hold tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator.
4.Keep guards in place.
5.Use only wheels having a maximum operating speed at least as high as "No Load RPM" marked on the tool's nameplate. When using depressed center wheels, be sure t o use only
6.Check the wheel carefully for cracks or damage before operation. Replace cracked or damaged wheel immediately.
7. Use only flanges specified for this tool.
8.Be careful not t o damage the spindle, the flange (especially the installing surface) or the lock nut. Damage t o these parts could result in wheel breakage.
9.Hold the tool firmly.
IO.Keep hands away from rotating parts.
11. Make sure the wheel is not contacting the workpiece before the switch is turned on.
12.Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate poor installation or a poorly balanced wheel.
13.Use the specified surface of the wheel t o perform the grinding.
14.Watch out for flying sparks. Hold the tool so that sparks fly away from you and other persons or flammable materials.
15.Do not leave the tool running. Operate the tool only when
16.Do not touch the workpiece immediately after operation; it may be extremely hot and could burn your skin.
17.Check the backing pad carefully for cracks, damage or deformity before operation. Replace cracked, damaged or deformed pad immediately.
18.Hold the tool firmly.
19.Keep hands away from rotating parts.
20.Make sure abrasive disc is not contacting the workpiece before the switch is turned on.
21.Do not leave the tool running. Operate the tool only when
22.Do not touch the workpiece immediately after operation; it may be extremely hot and could burn your skin.
SAVE THESE INSTRUCTIONS.
4
