TOOL INSTALLATION INSTRUCTIONS AND USE
Selecting compressor |
|
The air compressor must comply with the requirements of |
|
ANSI B19.3 - 1981. |
|
Select a compressor that has ample pressure and air output |
|
to assure |
|
relation between nailing frequency, applicable pressure and |
|
compressor air output. Thus, for example, if nailing takes |
|
place at a rate of approximately 40 times per minute at a |
|
compression of 6 kgf/cm2G(85 PSIG), a compressor with |
|
an air output over 3 ft3/minute is required. Pressure |
|
regulators must be used to limit air pressure to the rated |
|
pressure of the tool where air supply pressure exceeds the |
|
tool’s rated pressure. Failure to do so may result in serious |
|
injury to tool operator or persons in the vicinity. | Nailing frequency (timedmin.) |
Selecting air hose |
|
Use an air hose as large and as short as possible to assure |
|
continuous, efficient nailing operation. With an air pressure |
|
of 5 kgf/cm2G (70 PSIG), an air hose with an internal |
|
diameter of over 8.5 mm (5/16”) and a length of less than |
|
20 m (6.6 ft.) is recommended when the interval between |
|
each nailing is 0.5 seconds. Air supply hoses shall have a |
|
minimum working pressure rating of 10.7 kgf/cm2G (150 |
|
PSIG) or 150 percent of the maximum pressure produced |
|
in the system whichever is higher. |
|
CAUTION:
Low air output of the compressor, or a long or smaller diameter air hose in relation to the nailing frequency may cause a decrease in the driving capability of the tool.
Lubrication
To insure maximum performance, install an air set (oiler, regulator, air filter) as close as possible to the tool. Adjust the oiler so that one drop of oil will be provided for every 30 nails.
When n ir et is not used, oil the tool with pneumatic tool
Pneumatic tool oil
oil by placing 2 (two) or 3 (three) drops into the air fitting. This should be done before and after use. For proper lubri- cation, the tool must be fired a couple of times after pneu- matic tool oil is introduced.
11
