003042

Spade grip

 

 

 

1

2

 

The spade grip can be installed in any position as shown in

 

 

 

 

 

the figure. To change the position, loosen the hex bolts (both

 

 

 

sides) with a hex wrench and turn the spade grip to the

 

 

 

desired position. Then tighten the hex bolts securely. After

 

3

 

reposition the grip, return the hex wrench to the wrench

 

 

holder.

 

 

 

1. Spade grip

 

 

CAUTION:

2. Wrench holder

 

 

3. Hex wrench

 

 

• Do not fix the spade grip beyond the limits of the arrow.

 

 

 

Be cautious that your hand is not caught in the grip.

 

 

003043

Keep the hand away from the drill chuck. They can lead

 

 

 

 

 

 

to serious accidents.

 

 

 

• Always be sure that the hex bolts (both sides) of the

 

 

 

spade grip are tightened securely.

 

003054

Installing or removing drill bit

 

 

To install the bit, place it in the chuck as far as it will go.

 

 

Tighten the chuck by hand. Place the chuck key in each of

 

 

the three holes and tighten clockwise. Be sure to tighten all

 

 

three chuck holes evenly.

 

 

To remove the bit, turn the chuck key counterclockwise in just

1

 

one hole, then loosen the chuck by hand.

1. Chuck key

 

After using the chuck key, be sure to return to the original

 

 

position.

9

Page 9
Image 9
Makita DA4031, DA4030 instruction manual Spade grip, Installing or removing drill bit