P 4/ 5

Repair

[2]DISASSEMBLY/ASSEMBLY FOR DC18WA U

[2]-1. Terminal unit and Charger case complete

DISASSEMBLING

Important: After disconnecting the charger from electric outlet, wait more than 5 minutes before repairing work. Replace Charger case complete as drawn in Figs. 5 and 6.

Fig. 5

1.Turn Charger upside down and remove four Tapping screws.

2.Turn Charger over again and open Charger case complete from rear side.

Charger case complete

Tapping

screws

Terminal unit

Indication of

*Open from

Charger case cover

 

DC18WA U

this side

 

Note: Terminal unit is fully integral with Charger case complete.

When it is necessary to replace Terminal unit, replacing

Charger case complete and Charging condition label is required.

Fig. 6

3. Hold the connector on Charging circuit and pull up the connector.

Charging circuit

Connector

ASSEMBLING

Assemble Charger case complete to Charger case cover by reversing the disassembly procedure.

Be sure to push Power supply cord firmly between the ribs and the wall of Charger case cover as drawn in Fig. 7.

Fig. 7

Power supply cord

Page 4
Image 4
Makita dimensions DISASSEMBLY/ASSEMBLY for DC18WA U