Makita HPR2410 ASSEMBL Y

The torque limiter will actuate when a certain torque level is

reached. The motor will disengage from the output shaft.

When this happens, the bit will stop turning.

CAUTION:

•As soon as the torque limiter actuates, switch off the tool

immediately. This will help prevent premature wear of the

tool.

•Hole saws, core bits, diamond core bits, etc. cannot be

used with this tool. They tend to pinch or catch easily in

the hole. This will cause the torque limiter to actuate too

frequently.

ASSEMBLY CAUTION:

•Always be sure that the tool is switched off and

unplugged before carrying out any work on the tool.

The side grip swings around to either side, allowing easy

handling of the tool in any position. Loosen the side grip by

turning it counterclockwise, swing it to the desired position

and then tighten it by turning clockwise.

Coat the bit shank head beforehand with a small amount of

bit grease (about 0.5 - 1 g; 0.02 - 0.04 oz.). This chuck lubri-

cation assures smooth action and longer service life.

1. Side grip

2. Clamp screw

003143