Makita HR2445, HR2455 Bit angle (when chipping, scaling or demolishing), Depth gauge, Dust cup

Bit angle (when chipping, scaling or demolishing)

For Model HR2455 only

The bit can be secured at the desired angle. To change the

bit angle, depress the lock button and rotate the action mode

changing knob to the O symbol. Turn the bit to the desired

angle.

Depress the lock button and rotate the action mode changing

knob to the symbol. Then make sure that the bit is

securely held in place by turning it slightly.

The depth gauge is convenient for drilling holes of uniform

depth. Loosen the side grip and insert the depth gauge into

the hole in the side grip. Adjust the depth gauge to the

desired depth and tighten the side grip.

NOTE:

•The depth gauge cannot be used at the position where

the depth gauge strikes against the gear housing.

Use the dust cup to prevent dust from falling over the tool

and on yourself when performing overhead drilling opera-

tions. Attach the dust cup to the bit as shown in the figure.

The size of bits which the dust cup can be attached to is as

follows.

1. Lock button

2. Action mode changing knob

003576

003577

1. Depth gauge

003865

1. Dust cup

001300

Dust cup 5

Dust cup 9

Bit diameter

6 mm (1/4”) - 14.5 mm (9/16”)

12 mm (15/32”) - 16 mm (5/8”)

003578