13
Remove the crank cap using a hex wrench. Rest the tool on
the table with the bit end pointing upwards. This will allow the
old grease to collect inside the crank housing.
Wipe out the old grease inside and replace with a fresh
grease (60 g; 2 oz). Use only Makita genuine hammer
grease (optional accessory). Filling with more than the spec-
ified amount of grease (approx. 60 g; 2 oz) can cause faulty
hammering action or tool failure. Fill only with the specified
amount of grease.
Reinstall the crank cap and tighten with the hex wrench.
Connect the two terminals and reinstall the handle.
CAUTION:
•Do not tighten the crank cap excessively. It is made of
resin and is subject to breakage.
•Be careful not to damage the terminals or lead wires
especially when wiping out the old grease or installing
the handle.
To maintain product SAFETY and RELIABILITY, repairs, any
other maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always using
Makita replacement parts.
1. Hex wrench
2. Crank cap
1
2
003243
1. Hammer grease
1
003247
1. Terminals
2. White
3. Black
1
2
3
003249