Makita LS0711Z Vertical vise, Horizontal vise (optional accessory)

Vertical vise

The vertical vise can be installed in two positions on either

the left or right side of the guide fence or the holder assembly

(optional accessory). Insert the vise rod into the hole in the

guide fence or the holder assembly and tighten the screw to

secure the vise rod.

Position the vise arm according to the thickness and shape

of the workpiece and secure the vise arm by tightening the

screw. If the screw to secure the vise arm contacts the guide

fence, install the screw on the opposite side of vise arm.

Make sure that no part of the tool contacts the vise when

lowering the handle fully and pulling or pushing the carriage

all the way. If some part contacts the vise, re-position the

vise.

Press the workpiece flat against the guide fence and the turn

base. Position the workpiece at the desired cutting position

and secure it firmly by tightening the vise knob.

CAUTION:

•The workpiece must be secured firmly against the turn

base and guide fence with the vise during all operations.

Horizontal vise (optional accessory)

The horizontal vise can be installed on the left side of the

base. By turning the vise knob counterclockwise, the screw

is released and the vise shaft can be moved rapidly in and

out. By turning the vise knob clockwise, the screw remains

secured. To grip the workpiece, turn the vise knob gently

clockwise until the projection reaches its topmost position,

then fasten securely. If the vise knob is forced in or pulled out

while being turned clockwise, the projection may stop at an

angle. In this case, turn the vise knob back counterclockwise

until the screw is released, before turning again gently clock-

wise.

The maximum width of the workpiece which can be secured

by the horizontal vise is 120 mm (4-3/4”).

CAUTION:

•Grip the workpiece only when the projection is at the

topmost position. Failure to do so may result in

insufficient securing of the workpiece. This could cause

the workpiece to be thrown, cause damage to the blade

or cause the loss of control, which can result in

PERSONAL INJURY.

1. Vise arm

2. Vise rod

3. Guide fence

4. Holder

5. Holder assembly

6. Vise knob

7. Screw

002255

1. Vise knob

2. Projection

3. Vise shaft

4. Base

001807