Makita LS1030N MAINTENANCE

Make sure that the tool is unplugged. Secure the turn base at

right miter angle fully by means of the grip. Lower the handle

fully and lock it in the lowered position by pushing in the stop-

per pin.

Carry the tool by carrying grip as shown in the figure. If you

remove the holders, dust bag, etc., you can carry the tool

more easily.

CAUTION:

•Always secure all moving portions before carrying the

tool.

•Stopper pin is for carrying and storage purposes only

and not for any cutting operations.

MAINTENANCE CAUTION:

•Always be sure that the tool is switched off and

unplugged before attempting to perform inspection or

maintenance.

WARNING:

•Always be sure that the blade is sharp and clean for the

best and safest performance.

This tool is carefully adjusted and aligned at the factory, but

rough handling may have affected the alignment. If your tool

is not aligned properly, perform the following:

Loosen the grip which secures the turn base. Turn the

turn base so that the pointer points to 0° on the miter

scale. Tighten the grip and loosen the hex bolts securing

the guide fence using the socket wrench.

1. Stopper pin

001792

001774

1. Hex bolt

001781