Makita LS1212 Sub-fence R (optional accessory), Vertical vise

CAUTION:

•When performing left bevel cuts, flip the fence over to the

left position as shown in the figure. Otherwise, it will

contact the blade or a part of the tool, causing possible

serious injury to the operator.

Sub-fence R (optional accessory)

The sub-fence R can be installed on the right side of the

guide fence. Insert the rods of the sub-fence R into the holes

in the guide fence. Tighten the screws which come with the

sub-fence R to secure the sub-fence R.

CAUTION:

•When performing right bevel cuts, never use the sub-

fence R. It will contact the blade or a part of the tool,

causing possible serious injury to the operator.

Vertical vise

The vertical vise can be installed in two positions on either

the left or right side of the guide fence or the holder assembly

(optional accessory). Insert the vise rod into the hole in the

guide fence or the holder assembly and tighten the screw to

secure the vise rod.

Position the vise arm according to the thickness and shape

of the workpiece and secure the vise arm by tightening the

screw. If the screw to secure the vise arm contacts the guide

fence, install the screw on the opposite side of vise arm.

Make sure that no part of the tool contacts the vise when

lowering the handle fully and pulling or pushing the carriage

all the way. If some part contacts the vise, re-position the

vise.

Press the workpiece flat against the guide fence and the turn

base. Position the workpiece at the desired cutting position

and secure it firmly by tightening the vise knob.

CAUTION:

•The workpiece must be secured firmly against the turn

base and guide fence with the vise during all operations.

1. Sub-fence

002261

1. Sub-fence R

2. Screws

002229

1. Vise arm

2. Vise rod

3. Guide fence

4. Holder

5. Holder assembly

6. Vise knob

7. Screw

001796