Makita LS1221 Horizontal vise (optional accessory), Holders and holder assembly (optional accessories)

Press the workpiece flat against the guide fence and the turn

base. Position the workpiece at the desired cutting position

and secure it firmly by tightening the vise knob.

CAUTION:

•The workpiece must be secured firmly against the turn

base and guide fence with the vise during all operations.

Horizontal vise (optional accessory)

The horizontal vise can be installed in two positions on either

the left or right side of the base. When performing 15° or

greater miter cuts, install the horizontal vise on the side

opposite the direction in which the turn base is to be turned.

By flipping the vise nut to the left, the vise is released, and

rapidly moves in and out. To grip the workpiece, push the

vise knob forward until the vise plate contacts the workpiece

and flip the vise nut to the right. Then turn the vise knob

clockwise to secure the workpiece.

The maximum width of workpiece which can be secured by

the horizontal vise is 200 mm (7 - 7/8”).

CAUTION:

•Always rotate the vise nut to the right fully when securing

the workpiece. Failure to do so may result in insufficient

securing of the workpiece. This could cause the

workpiece to be thrown, cause damage to the blade or

cause the loss of control, which can result in

PERSONAL INJURY.

Holders and holder assembly (optional accessories)

The holders and the holder assembly can be installed on

either side as a convenient means of supporting workpieces

horizontally. Install them as shown in the figure. Then tighten

the screws firmly to secure the holders and the holder

assembly.

1. Vise plate

2. Vise nut

3. Vise knob

001839

1. Holder

2. Holder assembly

001809