Makita LS711D Horizontal vise (optional accessory), Holders and holder assembly (optional accessories)

Horizontal vise (optional accessory)

The horizontal vise can be installed on the left side of the

base. By turning the vise knob counterclockwise, the screw

is released and the vise shaft can be moved rapidly in and

out. By turning the vise knob clockwise, the screw remains

secured. To grip the workpiece, turn the vise knob gently

clockwise until the projection reaches its topmost position,

then fasten securely. If the vise knob is forced in or pulled out

while being turned clockwise, the projection may stop at an

angle. In this case, turn the vise knob back counterclockwise

until the screw is released, before turning again gently clock-

wise.

The maximum width of the workpiece which can be secured

by the horizontal vise is 120 mm (4 - 3/4”).

CAUTION:

•Grip the workpiece only when the projection is at the

topmost position. Failure to do so may result in

insufficient securing of the workpiece. This could cause

the workpiece to be thrown, cause damage to the blade

or cause the loss of control, which can result in

PERSONAL INJURY.

The holders and the holder assembly can be installed on

either side as a convenient means of supporting workpieces

horizontally. Install them as shown in the figure. Then tighten

the screws firmly to secure the holders and the holder

assembly.

When cutting long workpieces, use the holder-rod assembly

(optional accessory). It consists of two holder assemblies

and two rods 12.

CAUTION:

•Always support long workpieces level with the top

surface of the turn base for accurate cuts and to prevent

dangerous loss of control of the tool.

1. Vise knob

2. Projection

3. Vise shaft

4. Base

001807

1. Holder

2. Holder assembly

002247

1. Holder assembly

2. Rod 12

002246