Installing or removing battery cartridge
0 Always switch off the tool before insertion or removal of the battery cartridge.
.To remove the battery cartridge, pull out the set plate on the bottom of the tool and grasp both sides of the cartridge while withdrawing it from the barrel.
0 To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Snap the set plate back into place. Be sure to close the set plate fully before using the tool.
0 Do not use force when inserting the battery cartridge.
If the cartridge does not slide in easily, it is not being inserted correctly.
Charging
Plug the fast charger into your power source. Insert the battery cartridge so that the plus and minus terminals on the bat- tery cartridge are on the same sides as their respective markings on the fast charger. Insert the cartridge fully into the port so that it rests on the charger port floor.
Check to see that the charging light comes on. When it goes out, you may remove the fully charged battery cartridge.
After charging, unplug the charger from the power source.
CAUTION :
Set plate
Battery cartridge
*Your new battery cartridge is not charged. You will need to charge it before use.
If you try to charge a cartridge from a
When you charge a new battery cartridge or a battery cartridge which has not been used for a long period, it may not accept a full charge. This is a normal condition and does not indicate a problem. You can recharge the battery cartridge fully after discharging it completely a couple of times.
If you wish to charge two battery cartridges, allow 15 minutes between chargings on the fast charger.
5
