Makita VR250DWAE, VR250DA Installing or removing battery cartridge, Switch action, Operation

Installing or removing battery cartridge		Button
*Always switch off the tool before insertion
or removal of the battery cartridge.
*To remove the battery cartridge, open the
cover and withdraw the battery cartridge
from the tool while pressing the buttons
on both sides of the cartridge.
*To insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip it into place.
Always insert it all the way until it locks in	Cover	Battery cartridge
place with a little click. If not, it may acci-

Chargingi *Your new battery cartridge is not charged.

You will need to charge it before use. Use the high capacity battery charger Model DC1411 to charge the battery cartridge.

*Plug the high capacity battery charger into the proper A.C. voltage source. The charg- ing light will flash in green color.

*Insert the battery cartridge so that the plus and minus terminals on the battery car- tridge are on the same sides as their resDective markings on the high capacity

battery charger. Insert the cartridge fully into the port so that it rests on the charger port floor.

*When the battery cartridge is inserted, the charging light color will change from green to red and charging will begin. The charging light will remain lit steadily during charging.

*When charging is completed, the charging light color will change from red to green. The charging time is approximately one hour.

*After charging, unplug the charger from the power source.

CAUTION:

*The high capacity battery charger Model DC1411 is for charging Makita battery cartridge. Never use it for other purposes or for other manufacturer's batteries.

*When you charge a new battery cartridge or a battery cartridge which has not been used for a long period of time, it may not accept a full charge. This is a normal condition and does not indicate a problem. You can recharge the battery cartridge fully after discharging it completely and recharging a couple of times.

8

*If you charge a battery cartridge from a just-operated tool or a battery cartridge which has been left in a location exposed to direct sunlight or heat for a long time, the charging light may flash in red color. If this occurs, wait for a while. Charging will begin after the battery cartridge cools. The battery cartridge will cool faster if you remove the battery cartridge from the high capacity battery charger.

*If the charging light flashes alternately in green and red color a problem exists and charg- ing is not possible. The terminals on the charger or battery cartridge are clogged with dust or the battery cartridge is worn out or damaged.

*If you wish to charge two battery cartridge, allow 15 minutes between charging on the high capacity battery charger.

OPERATION

Switch action

CAUTION:

Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released.

To start the tool, simply pull the trigger.

Release the trigger to stop.		I
	-Switch trigger
	Q

Operation

Hold the tool straight when inserting /operating. Use the tool within the effective vibra- tions range at equidistant intervals. The effective air bubble removal range is about ten times the diameter of the vibrating head, or around 250 mm (9-27/32")with Model VR250DA I VRZ5ODWAE.

Do not use this tool to move concrete within a form. The mortar will just move away and the coarse aggregate will remain, causing segregation.

* 9

.-. . . . . .