K00017 STACKING KIT
Installation Instructions
1.The K00017 stacking kit is used for stacking an
on an | The bin must be leveled | 4. INSTALLATION OF WATER SHIELD: | ||
before proceeding. NOTE: | THIS STACKING KIT IS | A. | Remove angle “A”, the water pump, float valve | |
ALSO USED, WHEN STACKING |
| bracket assembly, and sump trough from top ice | ||
ICE MACHINES. |
|
| machine. | |
2. INSTALLATION OF | B. | Remove existing sheet metal screw at lower right | ||
A. | See service manual for uncrating and inspection of |
| corner of bulkhead below siphon tube. Locate water | |
| ice machine. |
|
| shield above the lower machine’s electrical box. Use |
B. | Remove top cover from ice machine (NOTE: do not |
| existing screw to fasten flange of shield to bulkhead. | |
| put screws back in.). |
|
| Apply RTV sealant to the top edges of flange to |
C. Set ice machine carefully and squarely on bin. |
| provide a watertight seal. | ||
D. Position shim angle, provided in kit, on right side, as | C. Reinstall the sump trough, float valve bracket | |||
| shown in Illustration 1. |
|
| assembly, and water pump. |
E.Add foam tape, as shown in Illustration 1.
F.With four screws, install top cover from kit on left
| side of ice machine (NOTE: flange goes over side | 5. INSTALLATION OF ICE CHUTE: | |
| panel.). | A. | Remove the ice chute from kit and set bottom |
G. | Remove |
| mounting brackets over angle “B” on |
3. INSTALLATION OF |
| machine (Illustration 3). | |
A. | See service manual for uncrating and inspection of | B. | Put angle “A” in slots of top mounting brackets and |
| ice machine. |
| secure in place. |
B. | Remove | C. | Check for free movement of water curtains. |
| screws on | D. | Proceed to ice machine service manuals for electrical |
C. | Set |
| and water |
|
|
| |
| should be inside |
|
|
D.Install four screws in bottom
E.Bolt
F.Reattach
Manitowoc Ice, Inc.
2110 South 26 Street, P.O. Box 1720, Manitowoc, WI |
|
Telephone | 8001403 |
Web Site - www.manitowocice.com | Rev. 05/11/01 |