K00214 ADAPTER KIT
Installation Instructions
1.The K00214 kit is used for installing 30" stacked units,
2.Installation (bin must be level before starting):
A.Remove existing foam tape from top of bin.
B.Place adapter on bin, as shown. Locate foam tape from kit in the Figure A positions on top of bin, as shown. Note locations of narrow and wide tape.
C.Place fillers on adapter, as shown. Make sure the two holes from the adapter and fillers are aligned on the side.
D.Using the fillers as templates, drill three 5/32” (4 mm.) holes, .500” (12.7 mm.) deep maximum in bin. Warning: Do not drill through interior liner. Attach with
E.Apply foam tape to the edge of the fillers and on the front and back of the adapter between the fillers in the Figure B positions. Note: It is recommended to RTV intersections and along front inside edge of foam tape (see Figure B) to prevent water tracking.
3.Refer to ice machine installation manual for ice machine installation procedures.
Wide Tape From
Kit Both Sides
Filler |
|
Fille | Installer: It is |
| Recommended to RTV |
Narrow Tape From | Intersections and Along |
Kit Both Sides | Front Inside Edge of Foam |
| Tape to Prevent Water |
| Tracking |
Adapter
Bin
Figure A
Figure B
Manitowoc Ice, Inc.
2110 South 26th Street, P.O. Box 1720, Manitowoc, WI |
|
Telephone | 8013853 |
Web Site - www.manitowocice.com | Rev. 05/12/04 |
