Section 4 | Maintenance |
|
|
Water Inlet Valve
The water inlet valve normally does not require removal for cleaning. Refer to Section 5 for a list of causes for “No Water Entering Water Trough” or “Water Overflows Water Trough.
1.When the ice machine is off, the water inlet valve must completely stop water flow into the machine.
2.When the ice machine is on, the water inlet valve must allow the proper water flow through it. Set the toggle switch to ON. Watch for water flow into the ice machine. If the water flow is slow or only trickles into the ice machine, refer to Section 5.
Follow the procedure below to remove the water inlet valve.
!Warning
Disconnect the electric power to the ice machine and dispenser at the electric service switch box and turn off the water supply before proceeding.
1.Remove the 1/4” hex head screws.
2.Remove, clean, and install the filter screen.
FILTER
ACCESS
SCREWS
WATER
INLET
VALVE
SV1622
Part Number |
