3 4 5 6 7 the Front Panel | Manley Labs 16 X 2 Tube Mixer specs

1 2 3 4 5 6 7 THE FRONT PANEL

1)MIC GAIN. This knob sets the mic preamp gain from 0 dB to 60 dB in 5 db increments. With highest gains, we advise a little caution. Suddenly a quiet mic or half working patch will decide to work and ka-boom... and you may regret not checking why you had to turn it up that far.

2)180. This micro toggle is used to reverse the polarity (phase) on the mic signal. It uses a relay rather than one more IC and lights a LED to clearly indicate "phase reverse".

3)INSERT. This micro toggle is used for inserting a compressor, EQ, or gate after the mic pre and before the Mix Gain pot. It also uses a relay to pick up the signal from the INSERT jack.

4)MIX GAIN. Sets the channel level to the CHANNEL OUTPUT jack and to the stereo mix buss. This is just like a fader on a large console. Unity gain (zero) is at approximately 2:00 on the knob and maximum gain is +10 dB with the knob fully clockwise.

5)SOLO. This button allows you to listen to this track only, by muting every other channel. Of course you can solo any number of tracks and mute channels that are also soloed. GREEN leds = SOLO, which also tends to also turn on many red MUTE leds.

6)MUTE. Simply removes that channel or track from the mix. The MUTE button has no effect on the CHANNEL OUTPUT jacks so they are available for direct outputs to a multi-track without also sending them to the mix. One can return the multi-track to any available channnels for mixing and monitoring. RED leds = MUTE.

7)PAN. Allows you to place the track across the left and right mix and position it where you want. This pan is 4.5 dB down in center like the old British desks. With the MIX GAIN fully clockwise, and PAN fully clockwise, the signal will have 10 dB of gain in the right channel and nothing in the left.

Manley Labs 16 X 2 Tube Mixer owner manual 3 4 5 6 7 the Front Panel

Models: 16 X 2 Tube Mixer

1 2 3 4 5 6 7 THE FRONT PANEL