CONNECTING YOUR AMPLIFIER
Setting up your amplifiers is rather easy.
1.Connect all source components (turntable, CD, Tuner, Tape DAT, etc.) to your preamplifier.
2.Connect the interconnects from the output of the preamplifier or switching center to the RCA input on the top rear of the amplifiers. IF your source has a truly BALANCED output, connect TO the XLR input and select the balanced input on the switch. If using a standard UNBALANCED source, select and use the unbalanced RCA connector. This amplifier will not function properly if you are using the wrong input for your application. The XLR inputs signals are transformer balanced and floating. Pinout is Pin 1: Ground; Pin 2: POSITIVE (+); Pin 3: NEGATIVE
3.Be sure to select XLR or RCA input depending on which one you are using. No tunes will get into the amplifier if you have the wrong input selected.
4.Connect the hot or "+" speaker cable to the red binding post and the common or
5.Ensure that the "mains" switch on the front panel is DOWN in the "off" or "0" position and the OPERATE / STANDBY switch is also down in the STANDBY mode.
6.Turn on Preamplifier and all the source components you plan to use.
7.Plug amplifier into wall outlet.
8.Switch the black
9.Engage the
10.Turn up the volume on your preamp and enjoy the glorious tunes. If you don't hear tunes, make sure you do not have the amplifiers MUTED... hit that MUTE switch.
11.After your listening session, if you wish to leave the amplifier in the
5