Manley Labs STEREO 75+75 WATT AMPLIFIER owner manual Connecting Your Amplifier

CONNECTING YOUR AMPLIFIER

Setting up your amplifiers is rather easy.

1.Connect all source components (turntable, CD, Tuner, Tape DAT, etc.) to your preamplifier.

2.Connect the RCA interconnects from the output of the preamplifier or switching center to the RCA input on the back of the amplifiers.

3.Connect the hot or "+" speaker cable to the red binding post and the common or "-" speaker cable to the black binding post. Ensure that the other end of the cable is connected correctly to the speaker. Tighten the binding posts by hand. If you use a nut-driver (3/8") do not over-tightenthe posts or you may break the connections inside the amplifier.

4.Ensure that the "mains" switch on the front panel is in the "off" or "0" posi- tion.

5.Turn on Preamplifier and any source components you plan to use.

6.Plug amplifier into wall outlet.

7.Switch the square mains power switch to the ON position and allow the amplifier a minute or so to 'warm up'.

9. Turn up the volume and enjoy.