Mantis ElectricTiller owner manual S e m bly, Parts

A s s e m bly

WARNING DANGER

IMPROPER ASSEMBLY OFTHISTILLER CAN RESULT IN SERIOUS INJURY.

MAKE SURETO FOLLOW ALL INSTRUCTIONS CAREFULLY.

IFYOU HAVE ANY QUESTIONS CONTACT OUR FACTORY AT

1-800-366-6268 OR AN AUTHORIZED DEALER.

A.Parts

Your MANTIS Electric Tiller comes partially assembled. You must install only the handlebars, the handle brace, and the tines. This will take just a few minutes if you follow the directions.

First, take all items out of the carton. But do not remove the cardboard from around the tiller’s base.

The list below, shows the parts that come with your tiller. Check to make sure you have them.

The bag of hardware is in the plastic bag containing the Owner’s Manual and Video.

To assemble your MANTIS Electric Tiller, you’ll need two 7/16" wrenches. We suggest that you install all nuts and bolts only “finger tight” — that is, one- half to one full turn — until you’ve completed assembly. The nuts are self locking, but you must use a wrench to tighten them completely.

Qty.	Description	*Key #
1	Upper Handle Assembly	7
1	Upper Handle Trigger Assembly	1
2	Lower Handles	10
1	Pair Tiller/Cultivator Tines	54/55

1Motor Assembly (includes Fender Guard, WormGear Transmission

	& Complete Housing)	62**
1	Handle Brace	14
1	Bag of Hardware Containing:
2	Round Head Square Neck Bolts	16
4	Lock Nuts	17
2	Bolts (3" long)	20
2	Tine Retaining Pins	53
2	Handle Clamps	19
2	Bolts (1" long)	13
2	Knobs	12
2	Cable Clamp	18

*These numbers are the same numbers shown on the Parts Layout on pages 16 and 17.

**This Key # is for assembly purposes only.

54, 55 62

1

14 7

10

12

13

16

20

18

17

19

53

5 Electric Tiller