Maintenance
WARNING – DANGER
UNPLUG THE UNIT BEFORE LUBRICATING
OR ADJUSTING THE BLADES.
A. Lubrication
1.A few drops of light No. 10 oil should be placed on the back edge of each adjusting screw head approximately after every 4 hours of normal operation.
2.To obtain trouble free trimming, it is necessary to keep the blades lubricated and clean. The gum that collects and builds up on the blades can be removed with a
3.When blades are replaced, or any other time that the bottom cover plate is removed, the grease level should be
checked for proper amount (approximately 1/2 full in the area of the gears) and a new gasket should be used to insure proper seating of the cover plate. Grease should be added every 25 hours of use. Use EP2 white lithium grease in the gear housing.
4.Lubricate male spline part of the drive shaft with EP2 White Lithium grease.
B. Storage
1.Store your trimmer in a dry and dust free space, out of the reach of children.
2.Clean the blades thoroughly and coat them with No. 10 oil to prevent rust.
3.Perform all required maintenance and service found in this manual.
4.Use blades cover.
Service maintenance guide
| Area | Maintenance | Before | Every 25 | Every 50 | Every 100 | Note |
|
|
| use | hours | hours | hours |
|
| Cutting parts | Replace if | ✔ |
|
|
|
|
|
| something is wrong |
|
|
|
|
|
|
|
|
|
|
|
|
|
| Gear case | Grease |
| ✔ |
|
| Use EP2 white |
|
|
|
|
|
|
| Lithium grease |
|
|
|
|
|
|
|
|
| Screws, nuts | Tighten, replace | ✔ |
|
| ✔ | Not adjusting |
| bolts |
|
|
|
|
| screws |
|
|
|
|
|
|
|
|
| Spline (male) | Lubricate | ✔ |
|
|
| Use EP2 white |
|
|
|
|
|
|
| Lithium grease |
|
|
|
|
|
|
|
|
| Blades | Oiling | ✔ |
|
|
| Light #10 oil |
|
|
|
|
|
|
|
|
IMPORTANT: Time intervals shown are maximum. Actual use and your experience will determine the frequency of required maintenance.
| Area |
| Maintenance procedure | Frequency |
|
|
|
| |
Spline male/female |
| Inspect/lubricate |
| |
connection of the |
|
|
|
|
inner drive shaft |
| 1. | Remove the side screw, and loosen |
|
|
|
| up other three as shown on the |
|
|
|
| diagram (left). |
|
|
| 2. | Pull the shaft from the gear housing. |
|
|
| 3. | Pull and clean internal shaft. | |
|
| 4. | Lubricate. | |
|
|
| ||
|
| 5. |
| |
| Lubricate | 6. | Do not allow any dirt and dust |
|
|
| on the internal drive shaft |
| |
|
|
|
| |
|
| 7. | Do not allow any dirt and dust |
|
|
|
| entering into the gear case |
|
|
|
|
|
|
8