ENGLISH
Operations
Getting
nMM7055
ON/STANDBYDISPLAY
Turning the power on
When the power is in standby, press ON/STANDBY.
•The protection indicator flashes for approximately 7 seconds, and the power switches on.
•The power indicator lights.
NOTE
When turning the power ON, turn the volume control of connected devices down to the minimum.
Switching the illumination lamp
ON/OFF
If the unit is being used with the factory settings, the illumination lamp lights.
You can turn the illumination lamp off if it is making the room too bright at nighttime.
Press DISPLAY.
Each time this button is pressed, the illumination lamp turns ON/ OFF.
started Part names Connections
STANDBY | Protection | Power indicator |
indicator | indicator |
|
nMM7025
ON/STANDBYDISPLAY
Turning the power standby
When the power is in power on, press ON/STANDBY.
The STANDBY indicator lights, and the power changes to standby.
NOTE
Even if the unit is switched to standby, some of the circuits are still active. If you will not be using this unit for a prolonged period (due to a holiday etc), remove the power plug from the wall socket.
Furthermore, to prevent unexpected accidents, make sure the power plug is located where it can be removed at any time.
Setting the power to standby automatically
(Auto standby function)
When the auto standby function is set to ON, if there are no signals input into this unit and no operations are performed for more than 30 minutes, the power of this unit automatically switches to standby.
• The factory setting is “Off”.
Press DISPLAY for more than 5 seconds.
The auto power off display switches as shown below according to the auto standby function.
•When the auto standby function is ON: Lit
•When the auto standby function is OFF: Off
Operations Explanation of terms
STANDBY | Protection Power indicator |
indicator | indicator |
Troubleshooting Specifications Index
9
