29
ENGLISH
TROUBLESHOOTING
If you think that something is wrong with your
player, first check the points listed below. Incorrect
operations can sometimes be taken for trouble and
malfunctions. If the trouble persists even after the
following points have been checked, consult your
dealer or nearest Marantz sales office or service
center.
Disc fails to turn.
• Has the mains cord been connected properly?
• Has the player been turned on?
• Has the disc been placed in the proper
position?
• Is the disc upside down? (Is the disc’s label
surface facing up?)
• Is the disc dirty?
• Is the disc scratched?
• Is the disc warped?
Disc turns but no sound is heard.
• Have the amplifier and speakers been connected
properly?
• Has the amplifier been turned on?
• Has the amplifier’s function or selector switch
been set to “CD” or “AUX” (or to whichever
connectors the player has been connected)?
• Is the amplifier’s volume at its lowest setting?
Disc starts turning but then stops at some
point.
• Is the disc dirty?
• Is the disc scratched?
• Is the disc warped?
• Is the disc an Audio CD? Is it a disc with MP3/
WMA files recorded onto it? CD-ROMs for
personal computers, etc. cannot be played.
No remote control operations.
• Is the transmitter of the remote controller pointed
at the remote sensor of the player? Is there
anything between the player and remote control
unit which is blocking the signals?
• Have the batteries of the remote controller run
down?
• Is a strong light shining on the remote sensor of
the player?
• Is the REMOTE CONTROL switch on the rear
panel set to the EXTERNAL position? (Set it to
the INTERNAL position if the player is to be used
on its own.)
CD-R/CD-RW discs cannot be played.
• Has the disc been placed upside down on the
disc tray?
• Is the recorded information in Audio CD (CD-DA)
format? Have the MP3/WMA files been recorded
correctly?
OTHERS
The section describes the care and maintenance
tasks that must be performed to optimize the
operation of your Marantz equipment.
7 Cleaning of equipment external
surfaces
The exterior finish of your unit will last indefinitely
with proper care and cleaning, Never use scouring
pads, steel wool, scourging powders or harsh
chemical agents (e.g., lye solution), alcohol, thinner,
benzine, insecticide or other volatile substances as
these wil mar the finish of the equipment. Likewise,
never use cloths containing chemical substances. If
the equipment get dirty, wipe the external surfaces
with a soft, lint-free cloth.
If the equipment becomes heavily soiled:
• dilute some washing up liquid in water, in a ratio
of one part detergent to six parts water.
• dip a soft, lint free in the solution and wr ing the it
is damp.
• wipe the equipment with the damp cloth.
• dry the equipment by wiping it with a dry cloth.
7 Repairs
Only the most competent and qualified service
technicians should be allowed to service the
factory-trained warranty station personnel have
the knowledge and special facilities needed for
repair and calibration of this precision equipment.
After the warranty period has expired, repairs will
be performed for a charge if the equipment can be
returned to normal operation.
In the event of difficulty, refer to your dealer or write
directly to the nearest location to you that is listed
on the Marantz Authorized Service Station list. If
writing, please include the model and serial number
of the equipment together with a full description of
what you think is abnormal about the equipment’s
behaviour.