English
REMOTE CONTROL UNIT RC8000PM
The RC8000PM can be used to control a Marantz AV component equipped with a remote sensor as well as other Marantz compo- nents connected to the first component through the Remote Control Bus. The buttons of the RC8000PM are laid out on its control panel according to the functional groups as described below.
SYSTEM SOURCE
zON OFF ON/OFF AMP
PHONO | CD | TUNER | x | |
| ||||
AUX1 | AUX2 | TAPE | MD |
|
1 | 2 | 3 | A, F/P |
|
4 | 5 | 6 | B, |
|
7 | 8 | 9 | MODE |
|
– | 0 | + | MEMO |
|
|
|
| ||
SCROLL CANCEL | TEXT | TIME |
| |
|
|
| MUTE | v |
|
|
| VOLUME | |
|
|
|
| |
|
|
| UP |
|
|
| OPEN/ | VOLUME | c |
|
| CLOSE | DOWN |
|
RC8000PM
REMOTE CONTROL UNIT
zPOWER ON/OFF
a. SYSTEM ON button
The equipment of Marantz can be turned on at the same time in this button.
(However, this operation is limited to the equipment of Marantz with the standby function.)
b. SYSTEM OFF button
The equipment of Marantz can be turned off at the same time in this button.
(However, this operation is limited to the equipment of Marantz with the standby function.)
c. SOURCE ON/OFF button
After the AMP button is pushed, this button is pushed, the set is turned on and off.
xFUNCTION SELECT button
TUNER button : When this button is pushed the input of
TUNER is selected.
PHONO button : When this button is pushed the input of PHONO is selected.
MD button : When this button is pushed the input of
AUX button : When this button is pushed the input of AUX is selected.
cVOLUME UP/DOWN button
UP button : VOLUME knob turns when this button is pushed and the volume level is grows.
DOWN button : VOLUME knob turns when this button is pushed and the volume level is falls.
vAUDIO MUTE button
When this button is pushed, the sound is not temporarily emitted from the speakers.
When this button is pushed again, MUTE is released. Moreover, when up/down of the volume is operated by remote control, MUTE is released.
Other buttons are not applied to PM4000.
Please see at the owners manual of other equipment’s about the operation of button.
USING THE REMOTE CONTROL UNIT
1. Remote control
Operate the remote control unit within a distance of approx. 5 m from the infrared signal reception window (remote sensor) on the front of the Amplifier.
Remote control operation may not be possible if the remote control unit's transmitter is not pointing in the direction of the remote sensor or if there is an obstruction between the transmitteote sensor.
Remote control operating range
Amplifier
Approx. 5 m
60°
Remote control unit
2. Loading batteries
Batteries in this remote control unit have a life of approximately 1 year under normal operating conditions. When the remote control unit is not to be used for an extended period of time, remove the batteries. Also, when you notice that the batteries are starting to run down, replace them as soon as possible.
(1)Remove the battery cover.
Remote control unit
Rear side
(2)Insert batteries with correct + / – orientation.
Two AA
(3)Close the battery cover until it clicks shut.
7
