Mark Levinson manual Nº326S Preamplifier

Nº326S Preamplifier

Gain:	0, 6, 12, or 18dB in the line input stage
Volume control range:	80.0dB (maximum)
Gain resolution:	0.1dB steps above 23.0 in display (–57dB)
	1.0dB steps below 23.0 in display (–57dB)
Input overload:
when gain is set to +18dB:	1.6V on XLR, 0.8V on RCA
when gain is set to +12dB:	3.3V on XLR, 1.6V on RCA
when gain is set to +6dB:	6.6V on XLR, 3.3V on RCA
when gain is set to 0dB:	13.2V on XLR, 6.6V on RCA
Input impedance:	100kΩ
Output impedance:	less than 50Ω
THD + N	less than 0.001%
Crosstalk:	<90dB (any input to any output, input terminated)
Residual noise:	<-94dBV (20Hz to 20kHz, input terminated)
Frequency response:	10Hz-40kHz: ±0.2dB
Power consumption:	50 watts maximum
Mains voltage:	100V, 120V, 220V, or 230V, factory set for destination country
Mains frequency:	50 or 60Hz, factory set for destination country
Preamplifier inputs*:	(3) pairs balanced on XLR
	(4) pairs single-ended on RCA
Preamplifier outputs:	(1) pair balanced main output on XLR
	(1) pair single-ended main output on RCA
	(2) pairs record outputs on RCA

Other connectors:(2) link communication (one 8-pin modular RJ-45 connector for “slave-in” and one 8-pin modular RJ-45 connector for “slave-out”)

(1) phono ground on binding post

(1) IR input on 3.5mm miniature phone connector

(1)trigger programmable output on 3.5mm miniature phone connector (12V level or 5V pulse)

(1) RS-232 on 6-pin RJ-11 modular connector

(1) AC input on IEC-standard AC mains receptacle

Overall dimensions:	width:	17.75"	(45.1cm)
	height:	2.915"	(7.4cm)
	depth:	14.05"	(35.7cm)
Shipping weight:	30lb (14kg)

Remote control:Hand-held infrared remote control unit

Requires 2 AAA batteries (Alkaline batteries recommended).

*Nº326S phono input option is available at additional charge. When installed, input 7 becomes the phono input.

Unless otherwise noted, specifications reflect nominal values over 20Hz to 20kHz measured bandwidth on balanced XLR connections.

Specifications are subject to change without notice.

Mark Levinson® is a registered trademark of

Harman International Industries, Incorporated.

Not responsible for typographic errors.

Part # 072-16467

3 O a k P a r k , B e d f o r d ,	M A 0 1 7 3 0 - 1 4 1 3 U S A
T e l : 7 8 1 - 2 8 0 - 0 3 0 0	F a x : 7 8 1 - 2 8 0 - 0 4 9 0

w w w . m a r k l e v i n s o n . c o m