Nº436
Nº436/434 Mono Power Amplifiers
Rated power output: | Nº436 |
| 350W/ch continuous rms power @ 8Ω |
| 700W/ch continuous rms power @ 4Ω |
| Nº434 |
| 125W/ch continuous rms power @ 8Ω |
| 250W/ch continuous rms power @ 4Ω |
| all above power ratings measured as continuous (rms) power from |
| 0.5% THD (assuming that the AC mains can deliver adequate current, without its own voltage sagging) |
|
|
Frequency response: | within 0.3dB from 20Hz to 20kHz |
|
|
better than | |
(main outputs): | |
Voltage gain: | 26.8dB |
|
|
Input impedance: | 100kΩ (balanced) |
| 50kΩ |
Input sensitivity: | Nº436 |
| 2.42V for full rated output |
| Nº434 |
| 1.44V for full rated output |
|
|
Output impedance: | less than 0.05Ω from 20Hz to 20kHz |
Power consumption: | Nº436 |
| typically 525 watts (±5%) on |
| typically 100 watts (±5%) in standby |
Nº434
typically 275 watts (±5%) on typically 100 watts (±5%) in standby
Mains voltage: | 100V, 120V, 200V, 220V, or 240V at either 50 or 60Hz, factory set for destination country | |||
Connector complement: | (1) pair custom binding posts | |||
| (1) balanced input on XLR | |||
| (1) | |||
| (1) | 3.5mm trigger out jack | ||
| (1) | 3.5mm trigger in jack | ||
| (1) | |||
| (1) | |||
| (1) | |||
| (1) | |||
|
|
|
| |
Overall dimensions: | Nº436 |
|
| |
| width: | 17.75" | (45.1cm) | |
| height: | 7.65" | (19.4cm) | |
| depth: | 20.21" | (51.3cm) | |
| Nº434 | 17.75" | (45.1cm) | |
| width: | |||
| height: | 5.91" | (15.0cm) | |
| depth: | 20.21" | (51.3cm) | |
|
|
|
| |
Shipping weight: | Nº436 | 95lb | (43.7kg) each | |
| Nº434 | 65lb | (29.9kg) each |
Specifications are subject to change without notice.
Specifications are subject to change without notice.
Mark Levinson® is a registered trademark of
Harman International Industries, Incorporated.
Not responsible for typographic errors.
Part #
3 O a k P a r k , B e d f o r d , | M A 0 1 7 3 0 - 1 4 1 3 U S A |
T e l : 7 8 1 - 2 8 0 - 0 3 0 0 | F a x : 7 8 1 - 2 8 0 - 0 4 9 0 |
w w w . m a r k l e v i n s o n . c o m