My modules will not react to my remote / sensor.

When you use a remote or sensor, you should have at least one TM13 Transceiver or Marmitek Security Console installed in your house. These components will translate the radio signals to the Marmitek X-10 signal on the power line. Only one Transceiver should be installed for all remotes and sensors set to the same House Code.

Am I able to increase the range of my remotes by using more Transceivers?

Yes, you can use more than one TM13 Transceiver in your home when the range of your remotes is not sufficient. The TM13 is using so called collision detection to prevent signals to be disturbed when more than one TM13 is transmitting. TM13’s will wait for a quite power line before transmitting their data. To prevent your Marmitek X-10 System to become slow or to prevent dimming from becoming less smooth, make sure that the TM13 units are placed as far away from each other as possible.

USER INSTRUCTIONS LM15 LAMP MODULE

Compared to most X-10 Modules the LM15 does not have code wheels. The code can be set up by using any X-10 Controller. Because the LM15 will remember the installed Code even after a power loss, the LM15 can be set up before it will be installed at its final location (for instance an outside lamp).

1.Remove your light bulb from its socket and insert the LM15 into the light socket.

2.Insert a light bulb (100W max. open shade, 60W max. closed shade) into the LM15.

3.Set a Marmitek X-10 Controller (f.e. EasyControl8 or IRRF7243) to the required House and Unit Code.

4.Turn the power off and wait a few seconds.

5.Turn the power back on again.

6.You now can give a new code for the Lamp Socket within 30 seconds. Press the ON button (corresponding to the Unit Code you want the LM15 to respond to) on the X-10

Controller, 3 times, at about 1 seconds intervals. On the third press the lamp will turn on signifying that the code has been learned. NOTE: To set the code from an IRRF7243 Mini Controller press the Unit Code button 3 times.

Technical data

Supply voltage:

230V ±10% 50 Hz

Supply current :

< 20 mA capacitive

Switching power:

max. 100 W/230V for open shades, max. 60 W/230V for closed

 

shades. Does not contain a dimmer.

Signal sensitivity:

15 mVpp min 50 mVpp max at 120 kHz

Input impedance:

> 55 Ohm (L - N) at 120 kHz

Ambient temperature:

- 10° C to + 50° C (operation) - 20° C to + 70° C (storage)

Dimensions:

Ø 46x93 mm

Environmental Information for Customers in the European Union

European Directive 2002/96/EC requires that the equipment bearing this symbol on the product and/or its packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product should be disposed of separately from regular household waste streams. It is your responsibility to dispose of this and other electric and electronic equipment via designated collection facilities appointed by the government or local authorities. Correct disposal and recycling will help prevent potential negative consequences

to the environment and human health. For more detailed information about the disposal of your old equipment, please contact your local authorities, waste disposal service, or the shop where you purchased the product.

ENGLISH

LM15TM

5