10 MARMITEK
• You can only learn the codes for one original remote control per mode, e.g. the
codes for your DVD remote control under the DVD button. With some combi devices
(e.g. a TV with built-in DVD player) you first have to learn the TV functions in TV
mode and then the DVD functions in DVD mode.
Learning the commands
1. Point your existing remote control at the Marmitek EasyControl 6 remote control
(front to front). Keep a distance of 2,5 cm between the remote controls.
2. Press the SETUP (9) button until one of the Mode LEDs stays lit. Release the SETUP (9)
button.
3. Press the Mode button (TV, AUDIO, SAT, etc.) for the device you want to learn.
The LED will flash once.
4. Press the LEARN (3) button. The LED will flash once.
5. Press the button on the Marmitek remote control you want to store the new
command under. The LED will blink once.
6. Depending on the type of remote control you have, you can use one of two methods:
a. Press the button on the existing remote control you want to learn. Keep this button
pressed until the LED on the Marmitek remote control extinguishes. If the LED does
not extinguish, but starts flashing, you need to use method B. (If you have just tried
method A and want to try method B, first repeat step 5).
b. Press the button on the existing remote control you want to learn. Keep this button
pressed as long as you would when using the original remote control.
7. Repeat steps 5 and 6 for every button you want to learn.
8. When you have finished learning the buttons, press SETUP (9)
Erasing the commands learned per mode to clear memory space
You can erase the commands learned and saved for each separate function
(TV, VCR, etc.):
1. Keep the SETUP (9) button pressed until one of the Mode LEDs stays lit. Release the
SETUP (9) button.
2. Press the Mode button of your choice (TV, VCR, etc.). The LED will flash once.
3. Press the LEARN (3) button twice.
4. Press SETUP (9). The LED will extinguish after a few seconds.
5. All commands learned and saved for the selected function have now been erased.
4.6 Setting the standard volume for the satellite receiver
The volume for the SAT mode is controlled via the TV by default. Some satellite decoders
have their own volume control. You can program this function in such a way the volume
can be controlled directly via the satellite receiver.
1. Press the TV button (2) and release it. The remote control has to be set to TV mode
for this procedure.
2. Press SETUP (9) and keep this button pressed until one of the Mode LEDs stays lit.
3. Release SETUP (9).
4. Press ‘ Mute’ (5) and keep this button pressed, The LED will extinguish.
Keep the button pressed for about 8 seconds, until the LED starts flashing.
5. The volume can now be controlled via the satellite receiver.
Repeat this procedure if you want to return to normal volume control via the TV.