Installation and Initial Setup
■Unpacking
Carefully unpack the V-R1041DP-AFHD monitor and verify that the following items are included:
•V-R1041DP-AFHD Monitor
•V-PS12-5V-XLR Power Supply with 4-Pin XLR Connector
•Operating Instructions
Inspect the unit for any physical damage that may have occurred during shipping. Should there be any damage, immediately contact Marshall Electronics at (800) 800-6608. If you are not located within the continental United States, call +1 (310) 333-0606.
■Installation
The V-R1041DP-AFHD monitor is shipped with a ¼”-20 mounting bracket on the bottom side, allowing the monitor to be flexibly mounted to a camera or other device using a variety of mounts. This ¼”-20 mounting bracket can also be attached to any side of the monitor.
Alternately, the V-R1041DP-AFHD can be used in a desktop configuration with optional stand (Marshall part number VP-0113-DS-A), or mounted in 19” inch rack with optional adapter (Marshall part number V-R104-1M).
¼”-20 Mounting Bracket can also be attached to any side of the monitor
V-R1041DP-AFHD with optional desktop stand
■Connections and Power-On
Plug the V-PS12-5V-XLR power supply into an AC power source (100-240 V @ 50/60 Hz). Attach the 4-pin XLR connector to the back of the monitor. Please note that 12VDC can be also supplied directly to the monitor from a variety of sources. The monitor will draw approximately 2 Amps at 12 Volts in operation.
Connect the required cables for video signal input and output. (Power must be applied to the V-R1041DP-AFHD for the active loop-though outputs to be activated.) All BNC connectors are rated at 75Ω.
Turn on the unit by pressing the power button located on the front panel. Select a video input by pressing the corresponding input select button.
