Marshall electronic V-R171P-HDA warranty Operational Setup, Connectors, Marshall Electronics

4Operational Setup

1.Unpack the V-R171P-HDA and accompanying power supply. Physically inspect for any damage that may have occurred during shipping. Should there be any damage, immediately contact Marshall Electronics at 800-800-6608. If you are not located within the continental united states call +1 310-333-0606.

2.Install in your desired location.

3.Connect required cables for signal input and output.

4.Attach battery (Optional) or power connection from power supply to the back of the unit.

5.Plug the power supply into the A.C. source

6.Turn on the V-R171P-HDA by depressing the power switch located on the front of the unit. Refer to Page 4 picture for location of switch settings.

7.Perform input selections and screen adjustments as detailed in following sections of this document.

5Connectors

Tally IN HD-15 Female

12 VDC from power supply

4 Pin Male XLR

Pin 4 - Pos

Pin 1- Neg

Pin1- Green	in8-
Pin2- Red	Pin 9-
Pin3-Amber	Pin10-
Pin4 Ground	Pin11-
Pin5- Ground	Pin12-
Pin6-	Pin13-
Pin7-	Pin14-
	Pin15-

Component Video

75Ω Terminated

Composite

Video

75Ω Terminated

DVI-D In

SXGA IN

HD-15 Female

Pin1-Red IN	Pin 9-
Pin2-Grn IN	Pin10-
Pin3-Blu IN	Pin11-
Pin4-	Pin12-
Pin5-	Pin13-
Pin6-Gnd	Pin14-HSync
Pin7-Gnd	Pin15-VSync
Pin8-Gnd

S-Video IN

4 Pin Din (Female)

Pin1 - GND	Pin3	– Y in
Pin2 - GND	Pin4	– C in

Marshall Electronics 3