MartinLogan C2 user manual Connection, Installation, Break In, Installing On A Flat Surface

Connection
WARNING! Turn your amplifier	Fig. 1
off before making or breaking any
signal connections!
These speakers are designed with easy-to-use
push-style binding posts that accept bare wire or
pins (fig. 2). Additionally, by removing the rubber
inserts, they will accept banana plugs (fig. 3)
Assign the same color to the (+) and (–) terminals
on both the speaker and the amplifier. Make certain
that all connections are tight.

Fig. 2 Fig. 3

Installation

WARNING! Installation other than that described in the body of this document requires specific documentation from MartinLogan.

BREAK IN

Allow approximately 72 hours of break-in at 90 dB (moderate listening levels) before any critical listening.

INSTALLING ON A FLAT SURFACE

If you have a surface that provides a wide, level, and stable platform, the speaker can be placed directly on top. When using the speaker in this configuration, affix the pads to the bottom of the speaker at the rear contact points. Note: This

speaker is not magnetically shielded and therefore should not be placed directly beside or atop a CRT television.

REMOVING THE LOGO BADGE

To remove the logo badge unbend the tab on the back side of the logo then gently pull it away from the speaker grill (fig. 8).

Fig. 4

4