HOW TO ADD, CHANGE, OR DELETE CODES
Steps must be performed within 5 seconds of each other or lock will time out and go into sleep mode. Primary Code is always stored in the UP arrow position and can only be changed, not deleted. Guest Codes can only be stored in the RIGHT, DOWN or LEFT arrow positions and can be changed or deleted. (Fig. A)
1.Open the lock using the Primary or Backup Master Code.
2.Press and hold the center button for 2 seconds. Center button lights white indicating program mode.
3.Each arrow position with a stored code lights blue.
4.Press the arrow where a new code will be stored or an existing code will be changed or deleted.
5.Press the center button. The selected arrow from step 4 blinks twice.
6. If adding or changing a code: | If deleting a Guest Code: |
HOW TO CHANGE THE BATTERY
1.Open the lock.
2.Pull out the battery drawer and remove the old battery. (Fig. B)
3.Install a new CR2032 battery with the positive (+) side facing the (+) cutout in the drawer (down).
4.Close the battery drawer.
Note:
* If battery voltage is insufficient to unlock the lock, pull |
out the battery drawer to expose the battery jump slot. |
Do not force the drawer open further. It will not extend |
fully in the locked position. Place a new CR2032 battery |
in jump slot with positive (+) side of battery facing |
toward the lock face and start at step 1. (Fig. C) |
Jump Slot
Fig. B
7.Select a new code, between
8.Enter that code by pressing the corresponding arrows.
9.Press the center button.
10.
11.Press the center button.
12.Repeat steps
13.Save your codes at the back of this manual or store them
safely at: www.masterlock.com
Press and hold the selected arrow for 5 seconds until center button lights green. Code deletion is complete.
Primary Code
UP
LEFT RIGHT
Guest Guest
Code Code
DOWN
Guest Code
Fig. A
** Program mode cannot be accessed when the lock is |
powered by a battery in the jump slot. |
Fig. C
5 | 6 |