OWNER’S MANUAL
OPERATION
Continued
AUTO-IDLE OPERATION
IMPORTANT: Never start engine with electrical loads connected. Start engine before adding electrical loads.
1.If engine is cold, turn the
2.Start engine. Allow engine to warm up with no load for five minutes.
3.Turn
4.Operate generator according to speci- fications outlined in owner's manual.
5.Engine will automatically increase to normal operating speed when you plug load into any generator outlet.
Note: MGH10000C Only - The 250 Volt/50 Amp receptacle is not connected through the
6.The
Adjusting the Idle Speed
IMPORTANT: Adjust the idle speed only:
•If the idle speed becomes too high.
•If the engine idle speed will not regulate (en- gine idles and speeds up again and again).
1.Turn
WARNING: Always set the idle speed before turning on the Auto- Idle. If idle speed is not set, the largerresistoronthecontrolboard
Solenoid Bracket
M7 Nuts
MGH8500AIE
120V |
| ||
GFCI |
| ||
|
| 120V | |
R |
|
| |
ES |
| ||
TE | ET |
| |
|
| ||
ST |
| ||
HOUR | METER |
| |
E |
| ||
NM |
| ||
00000005 |
| ||
HOURS |
|
| |
| 1/10 | 120/240V | |
O- | |||
TWISTLOCK | |||
AUT | IDLE |
| |
|
| ||
OFF | ON |
| |
|
| ||
RESET |
| ||
|
| RESET |
Reset | 120 | Volt |
|
| |
Reset |
|
|
RESET
TEST
Off | Auto | Idle |
| ||
| Sel | On |
| ector | |
| E |
|
| NM |
|
| 00000 |
|
HOURS 005 | ||
|
| 1/10 |
MGH10000C
TWISTLOCK120V
TWISTLOCK120/240V
| 200 |
| Vp;t |
Reset |
|
Reset | Reset |
| |
| Reset |
may become hot. Heat from the resistormaydamagetheprotective coating on the control board.
2.Locate
3.Loosen two M7 nuts.
4.Rotate solenoid (located under the solenoid bracket) left or right to adjust
5.With a volt meter, check the
6.After reaching proper idle speed, tighten M7 nuts to secure solenoid to mounting bracket (see Figure 20).
Figure 20 - Solenoid Bracket Location (MGH10000C Shown)
Figure 19 - Control Panel
117846 | 13 |