FINAL INSTALLATION CHECKLIST
■Instructions and Installation Kit have been removed from tub.
■Washer is plugged into electrical outlet and is properly grounded.
■Water hoses are connected to the faucet’s with inlet screens and washers.
■Water is turned on and checked for leaks at faucet and water valve connections.
■Drain hose is properly located into drain facility and is not collapsed or damaged.
■Washer has been properly leveled. All legs should be firmly on the floor and leveling leg lock nuts MUST be tightened.
■Test for proper operation by running the washer through the following complete cycle.
FAV6800
1.Press “Normal” to turn the washer on.
2.Arrow up to select “Hot/Cold”
3.Press “Start/Pause” to begin the cycle.
4.Allow the Lid to lock and verify that the Lid has locked.
5.Allow the washer to fill with hot water.
6.Press “Start/Pause” to pause the cycle.
7.Allow the Lid to unlock, lift the Lid and verify the washer has filled with hot water.
8.Lower the Lid and Press “Off”.
9.Press “Normal”, Press “Bulky Items”
10.Arrow up to select “Cold/Cold”
11.Press “Start/Pause” to begin the cycle.
12.Allow the washer to fill with cold water.
13.Press “Start/Pause” to pause the cycle.
14.Allow the Lid to unlock, lift the Lid and verify the washer has filled with cold water.
15.Lower the Lid and press “Off”.
16.Press “Normal”, Press “Spin Only”.
17.Press “Start/Pause” to begin the cycle.
18.Verify the washer spins. This will take several minutes, the machine will first drain on slow spin speed.
19.Allow the Spin cycle to finish, verify that the Lid has unlocked at the end of the cycle.
20.Press “Off”.
FAV9800
1.Press “Home”, select “Set Your Own Cycle”, select “Cottons”, select “Hot Wash Cold Rinse”.
2.Press “Start/Pause” to begin the cycle.
3.Allow the Lid to lock and verify that the Lid has locked.
4.Allow the washer to fill with hot water.
5.Press “Start/Pause” to pause the cycle.
6.Allow the Lid to unlock, lift the Lid and verify that the washer has filled with hot water.
7.Lower the Lid and Press “Off”.
8.Press “Home”, select “Set Your Own Cycle”, select “Rinse or Spin Only Cycles”, select “Cold Rinse & Spin”; press “Start/Pause” to begin the cycle.
9.Allow the washer to fill with cold water.
10.Press “Start/Pause” to pause the cycle.
11.Allow the Lid to unlock, lift the Lid to verify that the washer has filled with cold water.
12.Lower the Lid and Press “Off”.
13.Press “Home”, select “Set Your Own Cycle”, select “Rinse or Spin Only Cycles”, select “Spin”.
14.Press “Start/Pause” to begin the cycle.
15.Verify the washer spins. This will take several minutes, the machine will first drain on slow spin speed.
16.Allow the Spin cycle to finish, verify that the Lid has unlocked at the end of the cycle.
17.Select “Ok”.
18.Press “Off”
Make any corrections necessary to properly complete the installation.
Page 3
