OPERATING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: If you do not follow these instructions exactly, a fire or
explosion may result causing property damage, personal injury or loss of life.
BEFORE OPERATING: ENTIRE SYSTEM MUST BE FILLED WITH WATER AND AIR PURGED FROM ALL LINES.
A.This appliance does not have a pilot. It is equipped with an ignition device which automatically lights the burner.
Do NOT try to light the burner by hand.
B.BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
•Do not try to light any appliance.
•Do not touch any electric switch;
Do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire
department.
C.Use only your hand to push in the gas control buttons. Never use tools. If the control buttons will not push in, don’t try to repair them, call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately contact a qualified installer or service agency to replace a flooded water heater. Do not attempt to repair the unit! It must be replaced!
OPERATING INSTRUCTIONS
1.STOP! Read the safety information above, on this label.
2.Set the thermostat to the lowest setting by first pressing
the COOLER 
and HOTTER 
buttons together and
holding for 1 second. Then press the COOLER 
button until the WARM indicator light appears.
3.Set the “ON/OFF” switch on the blower control box to the “OFF” position.
4.This appliance is equipped with a device which automatically lights the burner.
DO NOT TRY TO LIGHT THE BURNER BY HAND.
5. Wait five (5) minutes | to clear out any gas. |
If you then smell gas, | STOP! Follow “B” in the |
safety information above on this label. If you don’t smell gas, go to the next step.
6.Turn on all electrical power to the appliance.
7.Set thermostat to desired setting by first pressing the
COOLER 
and HOTTER 
buttons together and
holding for 1 second. Then press the HOTTER 
button.
8.If the appliance will not operate, follow the instructions “TO TURN OFF GAS TO APPLIANCE” and call your technician or gas supplier.
9.WATERTEMPERATUREADJUSTMENT
is approximately 120°F.
CAUTION: Hotter water increases the risk of scald injury. Consult the instruction manual before changing temperature.
WARNING: TURN OFFALL ELECTRIC
POWERBEFORESERVICING
TO TURN OFF GAS TO APPLIANCE
1.Set the thermostat to the lowest setting by first pressing the COOLER 
and HOTTER 
buttons together and holding for 1 second. Then press the COOLER 
button until the WARM indicator light appears.
2.Set the ON/OFF switch on the blower control box to the “OFF” position.
3.Turn off all electric power to the appliance if service is to be performed.
23
