BEFORE YOU CALL FOR SERVICE
Check these points if your
washer...
Won't fill
•Plugcord intoliveelectricaloutlet.
•Check fuseor resetcircuitbreaker.
•Turnthe controlknobto proper cycle and pull knob out to start thewasher. If equipped with buttons,be sure they are fully depressed,
•Turnboth Faucetson fully.
•Straighten inlet hoses,
•Disconnecthosesand check hose filter screens. Clean screens,if plugged,
•Checkfuseorresetcircuibreakt er.
•Turn the control knob to proper cycle and pull
knoboutto start the washer. If equipped with buttons,be surethey are fullydepressed.
*Closelid and pull knoboutto startthewasher.
Foryour safety,washerwill notagitateor spin unlessthe lidis closed.
•
close lid and pull knob out. Checkfor leveling. Be sure water level is acceptable for load size.
•Thismay be a pause or soak period in the cycle. Wait briefly and it may start.
•The washer is equipped with a lid switchfailure detector. In the eventthat the lid switch should
Won't agitate
•Check fuseor resetcircuitbreaker.
•Turnthe controlknobto proper cycle and puff knob outto startthewasher.If equippedwith buttons,be suretheyare fullydepressed.
•Close lid and pullknob outto startthe washer, Foryour safety,washerwill notagitate or spin
unlessthe lid is closed.
•The washer is equipped with a lid switchfailure detector. In the eventthat the lid switch should
malfunction, the detector will stop operations for your safety.Call for service.
Leaks water
•Make surehoseconnectionsare tight.
*Make sureend of drain hose is correctly insertedin and securedto drain facility.
Is noisy
• Make sure washer is level and firm to the floor.
malfunction,the detectorwill stop operations
for your safely.Coil for service,
Won't spin or drain
•Check fuseor resetcircuitbreaker.
•Straightenhoses.Eliminatekinkedhoses.If there isa drain restriction,call for service,
•Close lid and pull knob out to startthe washer.
Foryour safety,washerwill notagitate or spin unlessthe lid is closed,
•
•Sudslock - causedby too muchsuds.Rewash without detergent. Use correct amount of a low- sudsingdetergent,
•The washer is equipped with a lid switch failure detector. In the eventthat the lid switch should
malfunction,the detector will stop operations for your safety. Call for service.
Stops
•Plugcord intoliveelectricaloutlet.
PAGE8
Fills with the wrong temperature water
•Turnbothfaucetson fully.
•If equipped with a temperatureselectorknob,
be sureit issetdirectlyon a temperaturesetting and not betweensettings.
•Make sure temperatureselectionis correct.
•Make sure hosesare connectedto correct faucetsand inletconnections.Besurewater
supplyisregulatedcorrectly.Flushwater line beforefilling washer.
•Check thewater heater.It shouldbe setto
delivera minimum120°F (49°C) hotwater at the tap. Also checkwater heater capacity and recovery rate.
*Hosefilter screensplugged. Disconnecthoses and clean screens.
NOTE: Forfurtherassistanceontactyour Maytagdealer or call Maytag Customer
Service:
U.S.
Canada
I