Maytag MAH550 warranty Before You Call

Before You Call ....................................... .... .......

For problem laundry solutions (i.e. fabric damage, residue, tangling) and special laundry care proce-

dures, see the enclosed Laundering Tips booklet.

Check these )oints if your Maytag Neptune TM washer...

			• Use Max Extract option.
Load Is Too Wet at			•	Try using a high efficiency detergent		to reduce		sudsing.
End of Cycle			•	Load is too small. Very small loads (one or two items) may not
				spin out completely.
• •• .....•,	.•	• .•.	•	• ... *•. • . .... • . •.. • •....	,•. •	. •	• •	••....	• • .•. • . ••. •• ... •. •
			•	Door firmly closed.
			• Make sure hose connections are tight.
Leaks Water			•	Make sure end of drain hose is correctly			inserted and secured to drain facility.

•Avoid overloading.

•Use high efficiency detergent to prevent over-sudsing.

• •. • . • . ... • • ,, . ..... • • • . ..... • .. .... •.. •• *.. •.. .•... ....• •.. •• •

•Check fuse or reset circuit breaker.

•Straighten drain hoses. Eliminate kinked hoses. If there is a drain restriction, call f_ service.

Won't Spin or • Close the door and push the START/STOP button. For your safety, washer will n(

Draintumble or spin unless the door is closed.

•After pressing the START/STOP button, it may take a few moments before the clothe washer begins to spin. The door must lock before spin can be achieved.

•See "Tub is Completely Full of Suds" below.

• ••. ••. *•..•..., ,...•..•. •• .. ••..., • . • . .. •*. •• •. ••..•, ... •. •• • •

•Plug cord into live electrical outlet.

•Check fuse or reset circuit breaker.

•Turn the control dial to proper cycle and push the START/STOP button l start the clothes washer. If equipped with buttons, be sure they are fully depressed.

Stops• Close door and push the START/STOP button to start the clothes washer. For yo_ safety, washer will not tumble or spin unless door is closed.

•This may be a pause or soak period in the cycle. Wait briefly and it may start.

•Check screens on inlet hoses for obstructions. Clean screens periodically.

• .. • .. •. ••. ••• ••..•,• ••.* •.. ••* .. ...•• •• • . • . • . .•.... •. •. .. ••• ... •• • ..• . ...*.. ••• .. •

Tub is Completely Full of Suds

•Run the clothes washer through another complete cycle using cold water.

•Reduce detergent amount for that specific load size, soil level and water hardness.

•Use high efficiency or low sudsing detergent specially formulated for front load washel

• •• ....•• •. •. •. •, •...• • • • •..• •. •• .•.... ••. .... •• • ... ••.... •. •• • • ,

•Turn both faucets on fully.

•Check that the temperature selector button is fully depressed.

•Make sure temperature selection is correct.

•Make sure hoses are connected to correct faucets and inlet connections. Flush wal

Fills with		•	line before filling washer.
			Check the water heater. It should be set to deliver a minimum			120°F (49°C)		hot wal
the	Wrong		at the tap. Also check water heater capacity and recovery rate.
Temperature		•	Disconnect hoses and clean screens.		Hose filter screens may be plugged.
Water		•	When warm rinse is selected, only the final rinse will be warm. The					first t_
			rinses will be cold.
		• While the washer is filling for cold or warm wash temperatures, both hot and c(
			water will go through the dispenser as the automatic temperature control feature che¢
			incoming water temperatures. This is normal.
• *...•..•..•.	• • •.	•	.. •. •. •• ...	•. •••	• . • . ... ••. •• ...	*.•..••	....•.•..••	•.

10