CAREANDCLEANING
Control Panel - clean with a soft, damp cloth. Do not use abrasivesubstances.
Tumbler - remove any stains such as cray- on, ink pen or fabric dye (from new items such as towels or jeans) with an
stance. Once these steps are done, stains maystill be visible, but should not transfer to subsequent loads.
Cabinet- wipe off any marks withsoap and water.
Dryer Exhaust System - should be inspected and cleaned once a year to main- tain optimum performance, The outside exhaust hood should be cleaned more fre- quentlyto ensure proper operation. (Referto the Installation Instructions for more infor- mation.)
REPLACINGTHEDRUMLIGHT
Instructionsfor replacing the bulb:
1)Unplug or disconnect the dryer from the electrical power supply.
2)Open the door and use a Phillips screw- driver to removethe screw attaching the lens to the tumbler front.
3)Remove lens cover by pulling cover toward center of tumbler.
4)Rotate bulb
5)Replacethe bulb witha 120volt, 10 watt maximumcandelabra base light bulb.
6)Turn the light bulb clockwise into socket.
7)Replace lens cover by hooking plastic tabs into tumbler front below the light housing.
8)Reinstall the screw into the lens cover screw hole.
9)Reconnect dryer to power supply.
REVERSIH5[fiEDOOR
Directionsfor reversingthe dryer door:
1)Remove the hinge hole covers and screws.
2)While supporting the door, remove 2 screws in the hinges that secure the hinges to the cabinet.
3)Remove door by lifting slightly at the hinges and pulling the hinge tabs out of the hinge slots.
4)Movethe following parts to the opposite side of the door: 2 hinges and 4 hinge screws, 4 door screws, door strike and screw, inner door cover plate and screw,
5)Attach the door to the opposite side of the cabinet using the 2 counter sunk hinge screws. (See below). Screw the
lower hinge screw in first.This will help to align the door and hinges.
6)Replace the hinge hole covers to the opposite side.
.... Door Catch
..............i
n
I o _ | a |
Door
"_Screws
7
