Maintenance
Oven Door
CAUTION
Do not place excessive weight on or stand on an open oven door. This could cause the range to tip over, break the door, or injure the user.
Important: The oven door on a new range may feel “spongy” when it is closed. This is normal and will decrease with use.
Oven Window
To protect the oven door window:
1.Do not use abrasive cleaning agents such as steel wool scouring pads or powdered cleansers as they may scratch the glass.
2.Do not hit the glass with pots, pans, furniture, toys, or other objects.
3.Do not close the oven door until the oven racks are in place.
Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later date.
Storage Drawer
CAUTION
Do not store plastic, paper products, food or flammable materials in this drawer. The drawer may become too warm for these items when the oven is in use.
The storage drawer can be removed to allow you to clean under the range.
To remove:
1.Empty drawer and pull out to the first stop position.
2.Lift up the front of the drawer.
3.Pull out to the second stop position.
4.Grasp sides and lift drawer up and out.
To replace:
1.Fit the ends of the drawer glides into the rails in the range.
2.Lift up the front of the drawer and gently push in to the first stop position.
3.Lift drawer up again and push until drawer is closed.
Leveling Legs
CAUTION
Be sure the
Be sure the range should be leveled when installed. If the range is not level, turn the leveling legs, located at each corner of 
the range, until range is level.
BRACKET
LEVELING LEG
Oven Light
CAUTION
•Disconnect power to range before replacing light bulb.
•Allow oven to cool before replacing light bulb.
•Make sure bulb cover and bulb are cool before touching.
To replace oven light bulb: | BULB COVER |
1. When oven is cool, hold bulb |
|
cover in place, then slide wire |
|
retainer off cover. Important: |
|
Bulb cover will fall if not held |
|
in place while removing wire | WIRE |
retainer. | RETAINER |
|
2.Remove bulb cover and light bulb.
3.Replace with a
4.Replace bulb cover and secure with wire retainer.
5.Reconnect power to range. Reset clock.
Convenience Outlet
(Canadian models only)
The convenience outlet is located on the lower left side of the backguard. Be sure appliance cords do not rest on or near the surface element. If the surface element is turned on, the cord and outlet will be damaged.
The convenience outlet circuit breaker may trip if the small appliance plugged
into it exceeds 10 amps. To reset the circuit breaker, press the switch located on the lower edge of the backguard.
7
