6.Select Temperature and Soil Level Option.
7.Select Extra Rinse Option, if desired.
Water Inlet Hoses
This washer does not include water inlet hoses. The use of factory specified parts is recommended. See "Accessories" for a list of factory specified hoses available for separate purchase. These hoses are manufactured and tested to meet factory specifications.
Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of replacement on the label with a permanent marker.
8.To select cycle, push the Cycle Control knob in and turn clockwise to the cycle you want.
Moving and Storage
Because some water may stay in the hoses, freezing can damage your washer. If storing or moving your washer during freezing weather, winterize it.
Winterizing your washer
1.Shut off both water faucets. Disconnect and drain water inlet hoses. Pour 1 qt (1 L) of
2.Run washer on a drain and spin setting for about 30 seconds to mix the antifreeze and remaining water.
3.Unplug washer or disconnect power.
To use washer again
1. Flush water pipes and hoses. Reconnect water inlet hoses.
Turn on both water faucets. 9. Start the washer by pulling out the Cycle control knob.
NOTE: For best water savings, avoid stopping the washer, however if the washer does need to be stopped:
■■ To stop at any time, push in the Cycle Control knob.
■■ To restart, close the lid and pull out the Cycle Control knob.
WASHER CARE
Cleaning Your Washer
Use a soft, damp cloth or sponge to wipe up any spills such as detergent or bleach from the outside of your washer.
Clean your washer interior by mixing 1 cup (250 mL) of chlorine bleach and enough detergent to equal twice the manufacturer’s recommended amount for a normal wash load. Pour this mixture into your washer and run it through a complete cycle using hot water. Repeat this process if necessary.
Remove any hard water deposits using only cleaners labeled as washer safe.
Cleaning the liquid fabric softener dispenser
1.Remove dispenser by grasping top with both hands and squeezing, while pushing upward with thumbs.
2.Rinse dispenser under warm water, then replace it.
NOTE: To avoid damage to the washer or clothing, do not wash clothes with the liquid fabric softener dispenser removed.
2.Plug in washer or reconnect power.
3.Run the washer through a complete bulky items cycle with 1 cup (250 mL) of detergent to clean out antifreeze.
Storage, non-use, or vacation care
Operate your washer only when you are at home. If you will be on vacation or not using your washer for an extended period of time, you should:
1.Unplug washer or disconnect power.
2.Turn off the water supply to the washer. This helps avoid flooding (due to a water pressure surge) while you are away.
7
