![](/images/new-backgrounds/1255583/25558319x1.webp)
Put power supply cord through the strain relief. Be sure that the wire insulation on the power supply cord is inside the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Do not further tighten strain relief screws at this point.
Style 2: Direct wire strain relief
Unscrew the removable conduit connector and any screws from a 3/4" (1.9 cm) UL listed strain relief (UL marking on strain relief). Put the threaded section of the strain relief through the hole below the terminal block opening. Reaching inside the terminal block opening, screw the removable conduit connector onto the strain relief threads.
A
B
C
A. Removable conduit connector
B. Hole below terminal block opening
C. Strain relief threads
Put direct wire cable through the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Tighten strain relief screw against the direct wire cable.
4.Now complete installation following instructions for your type of electrical connection:
Electrical Connection Options
If your home has: | And you will be | Go to Section |
| connecting to: |
|
A UL listed, 120/240- | ||
(NEMA Type | volt minimum, | Power supply cord |
|
| |
| supply cord* |
|
A fused disconnect or | ||
| circuit breaker box* | Direct Wire |
5" |
|
|
(12.7 cm) |
|
|
A UL listed, 120/240- | ||
(NEMA type | volt minimum, | Power supply cord |
|
| |
| supply cord* |
|
A fused disconnect or | ||
| circuit breaker box* | Direct Wire |
3¹⁄₂" |
|
|
(8.9 cm) |
|
|
*If local codes do not permit the connection of a
10