Maytag W10239302A quick start Dryer Care, Cleaning the Dryer Location, Cleaning the Lint Screen

Models: W10239302A

1 32
Download 32 pages 8.8 Kb
Page 11
Image 11

This chart shows examples of items that can be rack dried and the suggested cycle, temperature setting and drying time. Actual drying time will depend on the amount of moisture items hold.

Rack Dry

Setting

Temp.

Time*

 

 

 

(Minutes)

 

 

 

 

Wool Sweaters

Timed

Low

60

Block to shape and lay flat

Dry

 

 

on the drying rack.

 

 

 

 

 

 

 

Stuffed toys or pillows

Timed

Low

60

Cotton or polyester fiber

Dry

 

 

filled

 

 

 

 

 

 

 

Stuffed toys or pillows

Timed

Air Only

90

Foam rubber filled

Dry

(no heat)

 

 

 

 

 

 

 

 

Sneakers or canvas shoes

Timed

Air Only

90

 

Dry

(no heat)

 

*Reset time to complete drying, if needed.

NOTE: You must remove drying rack for normal tumbling. Do not use Sensor cycles with the drying rack.

DRYER CARE

Cleaning the Dryer Location

Keep dryer area clear and free from items that would obstruct the flow of combustion and ventilation air.

Cleaning the Lint Screen

Every load cleaning

The lint screen is located in the door opening of the dryer. A screen blocked by lint can increase drying time. Clean the lint screen before each load.

To clean

1.Pull the lint screen straight up. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove.

2.Push the lint screen firmly back into place.

IMPORTANT:

Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so can cause overheating and damage to both the dryer and fabrics.

If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint. See “Venting Requirements” in the Installation Instructions.

As needed cleaning

Laundry detergent and fabric softener residue can build up on the lint screen. This buildup can cause longer drying times for your clothes, or cause the dryer to stop before your load is completely dry. The screen is probably clogged if lint falls off while the screen is in the dryer.

Clean the lint screen with a nylon brush every 6 months, or more frequently, if it becomes clogged due to a residue buildup.

To wash

1.Roll lint off the screen with your fingers.

2.Wet both sides of lint screen with hot water.

3.Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup.

4.Rinse screen with hot water.

5.Thoroughly dry lint screen with a clean towel. Replace screen in dryer.

Cleaning the Dryer Interior

To clean dryer drum

1.Make a paste with powdered laundry detergent and very warm water.

2.Apply paste to a soft cloth.

OR

Apply a liquid, nonflammable household cleaner to the stained area and rub with a soft cloth until all excess dye and stains are removed.

3.Wipe drum thoroughly with a damp cloth.

4.Tumble a load of clean cloths or towels to dry drum.

NOTE: Garments that contain unstable dyes, such as denim blue jeans or brightly colored cotton items, may discolor the dryer interior. These stains are not harmful to your dryer and will not stain future loads of clothes. Dry unstable dye items inside out to avoid transfer of dye.

11

Page 11
Image 11
Maytag W10239302A Dryer Care, Cleaning the Dryer Location, Cleaning the Lint Screen, Cleaning the Dryer Interior