When Moving Your Beverage Center:
Your beverage center is heavy. When moving the appliance for cleaning and service, be sure to cover the floor with cardboard or hardboard to avoid floor damage. Always pull the appliance straight out when moving it. Do not wiggle or “walk” the appliance when trying to move it, as floor damage could occur.
Front View
A
B
C
D
Clean Before Using
After you remove all of the packaging materials, clean the inside of your beverage center before using it. See the cleaning instructions in “Beverage Center Care.”
Important information to know about glass shelves and covers:
Do not clean glass shelves or covers with warm water when they are cold. Shelves and covers may break if exposed to sudden temperature changes or impact, such as bumping. Tempered glass is designed to shatter into many small,
Reverse Door Swing
(optional)
Tools Needed: Phillips screwdriver
1.Unplug beverage center or disconnect power.
2.Remove the screws from each side of the top of the beverage center cabinet and set aside.
NOTE: There are seven screws total. Do not discard.
3.Remove the hinge cover and washer and set aside.
Top View
A
BC
A. Top of beverage center cabinet
B. Hinge cover
C.Washer
4.Lift the door straight up and off of the bottom hinge.
5.Remove the screws fastening the bottom hinge and cover to the bottom of the beverage center cabinet. There are five screws total.
6.Move the bottom hinge and cover each to the opposite side of the bottom of the beverage center cabinet. Completely tighten the five screws.
A. Cover | C. Bottom hinge |
B. Bottom of beverage | D. Washer |
center cabinet |
|
7.Remove the two screws fastening the door stop spacer and the door stop to the bottom of the beverage center door.
8.Move the door stop spacer and the door stop to the opposite side and fasten with the two screws. Completely tighten the screws.
Bottom View
A
B
C
A. Bottom of beverage center door
B. Door stop spacer
C. Door stop
9.Place the washer onto the bottom hinge, then install the beverage center door onto the washer and hinge pin.
A
B
A. Bottom hinge washer
B. Bottom hinge
10.Align the top hinge washer with the hinge hole in the top of the door. Then, insert the top hinge pin through the washer and into the hinge hole.
11.Fasten the top hinge cover with three screws and move the remaining four screws to the opposite side. Completely tighten the seven screws.
AB
A. Top hinge washer
B. Top hinge
5